Specifying The Sensitivity Level For Paper Protection [Paper Protection Sensitivity] - Fujitsu fi-7160 Operator's Manual

Chapter 9 Operational Settings
HINT
If you scan a wrinkled document, paper protection may be set
off forcing a scan to be stopped even though paper is fed
normally. In this case, you can disable paper protection on the
operator panel for a single scan after paper protection is set off.
For details, refer to "Disabling Paper Protection for a Single
Scan After Paper Protection Is Set Off" (page
If paper protection is set off frequently, refer to
protection is set off frequently." (page
This setting can also be configured in the scanner driver or the
operator panel. When the operation panel setting is prioritized,
the operator panel setting is prioritized over the Software
Operation Panel setting. Note that even if the operation panel
setting is prioritized, the scanner driver setting has the highest
priority.
Specifying the Sensitivity Level for Paper
Protection
[Paper Protection Sensitivity]
Specify the sensitivity level to detect anomalies upon feeding
106).
the documents when paper protection is on.
"Paper
Documents are deformed (e.g. warped, bent, creased) or
150).
paper jam noise is made when documents are not being fed
by the rollers properly. To detect such a symptom and stop the
scan, select [Low] to only detect documents that are highly
deformed or paper jam noise that are loud. Select [High] to
also detect documents that are slightly deformed or small
paper jam noise.
1
2
Start up the Software Operation Panel.
For details, refer to "9.1 Starting Up the Software Operation Panel"
(page 163).
From the listing on the left, select [Device Setting 2]
[Paper Protection Sensitivity].
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
192