E" (Or Other Number/Letter) Is Already Displayed On The Function Number Display After Power-On - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Chapter 8 Troubleshooting
"E" (or other number/letter) is already displayed
on the Function Number Display after power-on.
Did you unlock the transport lock switch?
(fi-6230Z/fi-6240Z)
Yes
Does the problem persist after turning the power off then
back on?
Yes
Is "c" flashing on the Function Number Display, and is the
LED indicator flashing as well?
No
Turn off the scanner, and unlock the transport lock switch.
For details, refer to "Installing the Scanner" in Getting Started.
No
The scanner is operating correctly.
No
Close the ADF properly.
For details, refer to "1.4 Opening/Closing the ADF" (page
Yes
If the indication does not return to "1" (ready) after closing the ADF, check the
items in "8.4 Before You Contact the Scanner Service Provider" (page 149)
then contact your FUJITSU scanner dealer or an authorized FUJITSU scanner
service provider.
If the problem persists, check the items in
Service Provider" (page 149)
an authorized FUJITSU scanner service provider.
24).
"8.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
first,
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
138