Settings Related To Scanning; Adjusting The Position To Start The Scan [Offset/Vertical Magnification Adjustment] - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Chapter 9 Operational Settings

9.5 Settings Related to Scanning

Adjusting the Position to Start the Scan
[Offset/Vertical magnification Adjustment]
When the output position of the scanned image is not correct
or the image appears shortened/elongated (vertically), adjust
the offset and the vertical magnification in the following
procedure.
Normally, you should not have to make any adjustments as the
factory default settings are configured at appropriate values.
1
Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting] and
click the [Offset] button.
153).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
169