Table of Contents
Advertisement
Configuring the Software
Copyright © 2010, Juniper Networks, Inc.
The system automatically reboots.
CAUTION: During the upgrade process, the keyboard is locked to prevent interruption
of the firmware upgrade process. If the system loses power during the upgrade, the
upgrade will fail and the router may become unresponsive. Contact Juniper Networks
for assistance.
When the router reboots, log in to the router and verify the correct operation of the
3.
new software image. You must do this before you can change NVMRO back to the
locked (read-only) mode.
NOTE: If the diagnostics fail three times, the IPMI powers down and therefore cannot
display the reasons for the failure. When the temperature thresholds are reached, IPMI
sends notification to the shelf manager.
The installation procedure connects the device to the network but does not enable it to
forward traffic.
To configure the software:
NOTE: Make sure NVMRO is clear for the configuration changes to be saved permanently.
If not, the changes are lost on reboot.
Verify that the device is powered on.
1.
Log in as the root user.
2.
Start the CLI.
3.
root# cli
root@>
Enter configuration mode.
4.
configure
[edit]
root@#
Set the root authentication password by entering a cleartext password, or an
5.
encrypted password, or an SSH public key string (DSA or RSA).
[edit]
root@# set system root-authentication plain-text-password
New password password
Retype new password password
Configure an administrator account on the device.
6.
[edit]
Chapter 2: Installing the Software
17
Advertisement
Table of Contents
