mac-mode (Gigabit Ethernet)
Syntax
Hierarchy Level
Release Information
Description
Default
Options
Usage Guidelines
Required Privilege
Level
node-terminate-count
Syntax
Hierarchy Level
Release Information
Description
Options
Required Privilege
Level
Related Topics
Copyright © 2010, Juniper Networks, Inc.
mac-mode (sgmii | 1000base-x);
[edit interfaces interface-name mac-mode]
Statement introduced in Junos OS Release 10.0.
For Gigabit Ethernet interfaces only, specify whether the MAC address for the interface
is configured with the Serial Gigabit Media Independent Interface (SGMII) or 1000Base-X
physical layer protocol. Speeds of 10 Mbps and 100 Mbps are valid only with a MAC mode
of SGMII. Autonegotiation for MAC mode must be enabled for 1000Base-X.
SGMII
—Specifies the serial Gigabit Media Independent Interface.
sgmii
1000base-x
—Specifies the physical layer protocol.
See Configuring a Gigabit Ethernet Interface.
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
node-terminate-count count;
[edit protocol r2cp]
Statement introduced in Junos OS Release 10.2.
Configure the number of node terminate retransmits attempted when a node terminate
ACK has not been received before radio/router adjacency is terminated.
count
—Number of node terminate retransmits
Range: 1 through 5
Default: 3
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
R2CP Radio-to-Router Protocol Overview on page 45
Chapter 8: Summary of Junos Statements for the LN1000 Router
59