Table of Contents
Advertisement
Related Topics
Example: Configuring the PPPoE-Based Radio-to-Router Protocol
Requirements
Overview
Copyright © 2010, Juniper Networks, Inc.
Specify the logical Ethernet interface as the underlying interface for the PPPoE
3.
session.
Configure the operational mode as server.
4.
Optionally, identify the access concentrator by a unique name.
5.
Optionally, specify how many seconds to wait before attempting to reconnect.
6.
Optionally, provide a name for the type of service provided by the access concentrator.
7.
Optionally, configure the maximum transmission unit (MTU) of the interface.
8.
Optionally, configure the MTU size for the protocol family.
9.
Optionally, disable the sending of keepalive messages on the logical interface.
10.
For information on configuring a PPPoE server, see "Configuring Point-to-Point Protocol
over Ethernet" in the Junos OS Network Interfaces Configuration Guide.
This example shows how to configure the PPPoE-based radio-to-router protocol.
Requirements on page 37
Overview on page 37
Configuration on page 38
Verification on page 39
Before you begin:
Configure network interfaces. See Example: Creating an Ethernet Interface.
1.
Configure PPPoE interfaces. See Example: Configuring PPPoE Interfaces.
2.
Configure PPPoE encapsulation on an Ethernet interface. See Example: Configuring
3.
PPPoE Encapsulation on an Ethernet Interface.
Configure PPPoE encapsulation on an ATM-over-ADSL interface. See Example:
4.
Configuring PPPoE Encapsulation on an ATM-over-ADSL Interface.
Configure CHAP authentication on a PPPoE interface. See Example: Configuring
5.
CHAP Authentication on a PPPoE Interface.
In this example, you configure the ge-3/0/3 interface and set the bandwidth, resource,
latency, and quality to
100
options on the logical interface.
Chapter 6: Configuring PPPoE-Based Radio-to-Router Protocols
. You also set the threshold value to
10
, and then configure
37
Advertisement
Table of Contents
