Example: Pppoe Credit-Based Flow Control Configuration; Verifying Credit-Flow Control - Juniper JUNOS OS 10.3 - LN1000 MOBILE SECURE ROUTER USER GUIDE 8-26-2010 User Manual

Mobile secure router for junos os
Table of Contents

Advertisement

Junos OS LN1000 Mobile Secure Router User Guide

Example: PPPoE Credit-Based Flow Control Configuration

Verifying Credit-Flow Control

Purpose
Action
42
The interfaces statement includes the radio-router attribute, which contains the
parameters used for rate-based scheduling and OSPF link cost calculations. It also
includes the credit attribute to indicate that credit-based packet scheduling is supported
on the PPPoE interfaces that reference this underlying interface. Interfaces that set the
encapsulation attribute support the PPPoE Active Discovery Grant (PADG) and PPPoE
Active Discovery Credit (PADC) messages in the same way that the radio-router attribute
provides active support for the PPPoE Active Discovery Quality (PADQ) message.
The credit interval parameter controls how frequently the router generates credit
announcement messages. For PPPoE this corresponds to the interval between PADG
credit announcements for each session.
This example shows a PPPoE credit-based flow control configuration.
[edit interfaces ge-0/0/1]
unit 0 {
encapsulation ppp-over-ether;
radio-router {
credit {
interval 10;
}
bandwidth 80;
threshold 5;
}
}
Display PPPoE credit-flow control information about credits on each side of the PPPoE
session when credit processing is enabled on the interface.
user@host> show pppoe interface detail
pp0.51 Index 73
State: Session up, Session ID: 3,
Service name: None,
Configured AC name: None, Session AC name: None,
Remote MAC address: 00:22:83:84:2e:81,
Session uptime: 00:05:48 ago,
Auto-reconnect timeout: Never, Idle timeout: Never,
Underlying interface: ge-0/0/4.1 Index 72
PADG Credits: Local: 12345, Remote: 6789, Scale factor: 128 bytes
PADQ Current bandwidth: 750 Kbps, Maximum 1000 Kbps
Quality: 85, Resources 65, Latency 100 msec.
Dynamic bandwidth: 3 Kbps
pp0.1000 Index 71
State: Down, Session ID: 1,
Service name: None,
Configured AC name: None, Session AC name: None,
Remote MAC address: 00:00:00:00:00:00,
Auto-reconnect timeout: Never, Idle timeout: Never,
Underlying interface: ge-0/0/1.0 Index 70
PADG Credits: enabled
Dynamic bandwidth: enabled
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ln1000

Table of Contents