Installing A Netware Virtual Machine; Virtualization Host Server Requirements - Novell OPEN ENTERPRISE SERVER 2 SP2 - LAB GUIDE 01-19-2010 Manual

Installing a NetWare Virtual
2
Machine
Use the instructions in this section to install an Open Enterprise Server 2 (OES 2) virtual machine
host server in your lab, create a virtual machine on the server, and install NetWare
virtual machine.
This section describes the following:
Section 2.1, "Virtualization Host Server Requirements," on page 27
Section 2.2, "Installing the Virtualization Host Server," on page 28
Section 2.3, "Installing the NetWare 6.5 SP8 Virtual Machine," on page 36

2.1 Virtualization Host Server Requirements

For the tasks and exercises described in this section, you need the following in addition to those
listed in Section 1.1, "Lab Setup Requirements," on page
A server-class computer with the following:
Component
Processor
RAM
Display adapter
CD drive
Hard drive
(All data will be erased)
Network card
IP address
11.
Minimum
Pentium II or AMD K7 450 MHz
1 GB
Super VGA
Supports the ElTorito
Specification
40 GB
Ethernet 100 Mbps
Two IP addresses on the lab
subnet (one for the OES 2
VM host and one for the
NetWare VM). For example,
192.168.1.120 and
192.168.1.130.
Subnet mask. For example,
255.255.255.0.
Default gateway. For
example, 192.168.1.1.
®
6.5 SP8 on the
Recommended
Pentium III, Pentium III Xeon,
Pentium 4, Intel Xeon 700 MHz,
AMD K8 CPUs (Athlon64 and
Opteron), Intel EM64T or higher
processor
2 GB
VESA 1.2-compliant, high
resolution

Installing a NetWare Virtual Machine

2
27