Accessing Imanager - Novell OPEN ENTERPRISE SERVER 2 SP2 - LAB GUIDE 01-19-2010 Manual

net.slp.isDA = true
9 Save and close the file and the file browser.
10 Configure the firewall on the DA server to allow SLP daemon traffic:
10a Click Computer > YaST Administrator Settings, then click Security and Users > Firewall.
10b In the left navigation frame, click Allowed Services.
10c Click the Services to Allow drop-down list and select SLP Daemon.
10d Click Add > Next.
10e Click Accept.
11 Click Computer > Gnome Terminal.
12 At the command prompt, enter the following command to restart the SLP daemon with the
changed configuration:
rcslpd restart
13 Restart eDirectory by entering the following command:
rcndsd restart
This registers eDirectory as an SLP service.
14 After eDirectory restarts, enter the following command:
slptool findsrvs service:ndap.novell
After a moment or two, the system should respond with a line that indicates EXAMPLE_TREE
is being advertised as a service in SLP.
15 Close the terminal by entering the following command:
exit
16 Continue with

1.9 Accessing iManager

IMPORTANT: You must access iManager multiple times in this guide. If you get a Tomcat error in
response to any launch requests, see
Novell iManager is the main browser-based tool you use to manage eDirectory and your OES 2
services.
To start iManager and prepare your browser for future sessions:
1 On your lab workstation, in your Web browser, open the OES 2 Welcome page by entering the
following URL:
http://IP_or_DNS
where IP_or_DNS is the IP address or DNS name of your OES 2 server.
2 In the left navigation bar, click Management Services.
3 Under Available Services, click iManager.
You can also start iManager directly by including
For example, enter
24 OES 2 SP2: Lab Guide for Linux and Virtualized NetWare
Accessing iManager.
Section A.2, "iManager Tomcat Error," on page
http://192.168.1.100/nps
after in the access URL.
/nps IP_or_DNS
.
109.