Setting The Channel Level - Denon AVR-2807 Operating Instructions Manual

ENGLISH
Advanced Setup – Part 2
3 D D H H
Press to select the speaker, then press
to set.
4
ENTER
Press .
1
2
3
..... L1
..... L2
..... L3
..... L4
..... L5
..... L6
..... L7
..... L8
• Press D D to select "Step", then press F F G G to change the
amount of variation if so desired.
• The distance changes in units of 0.1 meters (1 foot) or 0.01
meters (0.1 foot) each time the button is pressed. Select the
value closest to the measured distance.
• Please note that the difference of distance for every
speaker should be 6.0 m (20 ft) or less. If you set an invalid
distance, a CAUTION notice, such as screen right will
appear. In such cases, move the appropriate speaker to the
position of the displayed value.

Setting the Channel Level

F F G G
Set the volume of the various speakers so that the sound output
from the speakers and the subwoofer seems to have the same
volume level.
1 D D H H
Press to select "Channel Level", then press
ENTER
.
2
F F G G
Press to set.
Auto:
Adjust the level while listening to the test tones produced
automatically from each speaker.
Test tones are automatically emitted from each speaker.
Manual:
Adjust with the speaker from which the test tone is output
switched manually.
3
D D H H
Press to select "Test Tone Start", then press
F F
to select "Yes".
4
When "Auto" mode is selected:
F F G G
Press to adjust the volume.
-1
• Test tones are output automatically, in the order shown
below.
FL C
SW SL
The volume can be adjusted within the range –12 dB to +12
dB.
4
When "Manual" mode is selected:
D D H H
Press to select the speaker, then press
-2
to adjust the volume.
5
ENTER
Press .
58
ENGLISH
1
4
-1
• To cancel the setting, press H H and select "Level Clear", then
press F F and select "Yes".
FR SR
(2 speakers)
• To adjust the channel level separately for the different play
SBL SBR
modes after setting the channel level, perform the operation on
(1 speaker)
SB page 34.
F F G G
Advanced Setup – Part 2
2
3
4
-2