Before Performing The Auto Setup Procedure; Perform The Auto Setup Procedure; Assigning Power Amplifiers; Switching The Front Speaker - Denon AVR-2807 Operating Instructions Manual

ENGLISH
Easy Setup Procedure
w Before performing the Auto Setup
procedure
1
Turn on your subwoofer.
Set the volume to halfway and set the crossover frequency
to the maximum or Low pass filter off if your subwoofer can
adjust the output volume and the crossover frequency.
Some subwoofers have a standby mode. Be sure to turn
this function off before performing the Auto Setup
procedure.
2
Turn on your monitor.
3 < POWER >
Press .
ON:
¢
The power indicator lights red.
OFF:
£
The power turns off and the indicator is off.
4
< ON/STANDBY >
Press or
• The power indicator blinks green and the power turns on.
e Perform the Auto Setup procedure
1
Press
2
Press
then press
3
Press
ENTER
The message "Connect Microphone" is displayed if no
microphone is connected. If so, connect the auto setup
microphone.
1
[ON]
.
• "System Setup Menu" is not displayed when using
headphones.
SYSTEM SETUP
.
D D H H
to select "Auto Setup / Room EQ",
ENTER
.
D D H H
to select "Auto Setup", then press
.
2
3
10
ENGLISH
Easy Setup Procedure
r Assigning power amplifiers
The surround back output can be assigned to the "Front" or
"ZONE2" output.
D D H H
Press to select "Power Amp Assign", then press
F F G G
to set.
Surround Back:
Assign to use as surround back speaker.
Front A, Front B:
Assign to use the "Front A" (or "Front B") speakers with bi-
amp connections.
ZONE2:
Assign to use as "ZONE2" speakers.
When assigned to "Front", skip the surround back channel
measurement.
During the auto setup procedure, test tones are not output
to "ZONE2".
t Switching the front speaker
D D H H
Press to select "Front Sp", then press
select the speaker.
Front A Front B
Front A+B
F F G G
to