Working With Songs And Loops; Selecting Songs And Loops; Using The Gnx3'S Footswitches For Recording; Recording A Track - DigiTech GNX3 User Manual

S/PDIF output. Configurations 2 and 3 are for the Dry Track setup (see the section on Digital Output
setup for more on Dry Track).
4. Press the EXIT button.

Working with Songs and Loops

A Song and a Loop are a group of recorded tracks. The GNX3's recorder has 99 songs available to record
to as recording memory allows. With an optional 128M Smart Media™ card, for example the GNX3 has a
total of 48 Normal quality track minutes available. This would be the equivalent of four 3-minute, 4-track
songs, leaving no memory available for songs 5-99. Loops, however, are generally shorter in length so more
loops could be saved than songs in the same amount of memory.

Selecting Songs and Loops

Selecting songs on the GNX3's recorder is easy. To select songs, follow these steps:
1. Press the STOP button (if the recorder isn't already stopped).
2. Use the F FWD or REWIND buttons to select the next or previous song. The GNX3's main display
reading
shows and the number in the SONG display changes as the new song is selected. The TIME
display shows the selected song's length.
NOTE: You can also use the DOWN and UP footswitches to select songs when Recorder
mode is active.

Using the GNX3's Footswitches for Recording

The GNX3's footswitches can perform different functions depending on what state they are in: Bank Mode,
Stompbox Mode, Learn-a-lick, and Recorder Mode. When Recorder mode is selected, the UP/DOWN
footswitches are used to select next and previous Songs. The 5 numbered footswitches are used for Rewind,
Undo, Stop, Record, and Play. To select the Recorder mode for using the footswitches to record, press the 4
and 5 footswitches simultaneously until the DOWN/UP footswitches are lit red. This turns your GNX3's
pedalboard into a hands-free remote control for the recorder.

Recording a Track

To begin recording a track using the footswitches, follow these steps:
1. Press the RECORD footswitch. The TRACK 1 button automatically lights red, indicating it is armed to
record, and the recorder begins recording on the track. The TIME display begins counting off the
recording time.
2. Once recording is completed, press the STOP footswitch. This stops the recording process, and the
track is saved. The TIME display shows the elapsed time used and the TRACK 1 button is lit green
indicating it is now enabled for playback.
Recorder
55