The Gnx3'S Modes; Bank Mode; Stompbox Mode - DigiTech GNX3 User Manual

Introduction
presets. When you select a preset, the name of the preset appears in the green alpha-numeric display and
the number of the preset appears in the red numeric display. The User LED to the right of the numeric
display lights indicating the User preset is active. The Factory LED lights indicating a Factory preset is
active.

The GNX3's Modes

When you first apply power to the GNX3, it powers up in one of three modes: Bank, Stompbox, or
Recorder. Modes are selected in two different ways:
1. Press the MODE button (located to the right of the DATA WHEEL).
OR
2. Press FOOTSWITCHES 4 and 5 simultaneously.
Depending on which mode is selected, the UP/DOWN footswitches will light a different color. When
Bank mode is selected, these footswitches will be lit green ( this is the default mode from the factory).
When Stompbox mode is selected, these footswitches will be lit yellow. And when Recorder mode is
selected, these footswitches will be lit red. In any of the modes, the display shows the selected preset's
name and number. The vertical LEDs on the Matrix indicate which effects are active for the selected
preset.

Bank Mode

When Bank Mode is active the UP/DOWN footswitches are used to select the 13 User Banks.
Successive presses of the UP/DOWN footswitches advances through all User/Factory Banks. Pressing
and holding a UP/DOWN footswitches scrolls through the User Banks. Once a Bank is selected, a
preset within that bank needs to be selected. If a preset is not selected within 5 seconds, the GNX3
returns to the previous bank and preset.

Stompbox Mode

Stompbox mode is another mode of operation that can be used during a performance. When Stompbox
mode is active, the UP/DOWN footswitches are used to select the GNX3's presets. The 1-5
Footswitches turn the effects on and off. FOOTSWITCH 1 turns the Distortion Stompbox modeling
on and off. FOOTSWITCH 2 switches between the Green, Red, and Yellow amp channels.
FOOTSWITCH 3 turns the Chorus/Mod Effects module on and off. FOOTSWITCH 4 turns the
Delay on and off. FOOTSWITCH 5 can be used to control any parameter in the GNX3 by either
toggling the parameter between 2 values or by momentarily changing a parameter's value while the pedal
is pressed and returning to its original value when the pedal is released (see Expression Pedal section on
page 61 for more information).
As an added feature, Footswitch 4 (the Delay footswitch) can be used as a tap-tempo switch for setting
the delay time during a live performance. To create a tap-temp switch, do the following:
10