Tuning With The Rp-12 - DigiTech RP12 Owner's Manual

RP-12 Owner's Manual

Tuning with the RP-12

• To scroll at high speed through the Programs in memory, press
and hold either the <UP> or <DOWN> Program key.
2) The second method uses the RP-12's pedalboard. When you
change programs using the pedalboard, any unstored modifications
you have made to a Program will be lost.
3) The third method is through the use of MIDI. This method will be
covered later in the MIDI section of this manual, pg. 58.
To access the Tuner using the RP-12 pedalboard, do the following:
• Press and hold the Bank Down/Tuner switch (in the lower right
corner of the pedalboard). The display reads:
TUNER A=44O
-- -- -- --
• Begin tuning your instrument. As you tune, the note name is
shown on the top line of the display, while vertical bars appear on
the second line of the display and begin strobing. If the note is
sharp, the bars will strobe from left to right. If the note is flat,
they'll strobe from right to left. When the note is in tune, the
strobing bars will stop moving and asterisks will appear around
the note name on the top line of the display.
After a few seconds of tuner inactivity, the display returns to:
TUNER A=44O
-- -- -- --
• Exit Tuning Mode by pressing any pedal or button.
13
Section 2 - Basic Operations