Starting With A Drum Count-In; Clearing/Restoring Song Parts; Guitar Fx - DigiTech TRIO Band Creator Manual

STARTING WITH A DRUM COUNT-IN

Sometimes it is desirable to hear a one-bar count-in before starting playback – for example, when recording
the output of the TRIO for the purpose of adding more parts, or when working on solos that start right on the
downbeat of a part.
To start with a drum count-in:
1. Start with the TRIO in the stopped state and select the part you wish to count-in to using the PART buttons.
2. Hold down the currently selected PART button until it starts to flash at the rate of the part's tempo.
3.
Now, when you step on the footswitch to start playback, you'll hear one bar of quarter notes played as a
count-in before the accompaniment starts.

CLEARING/RESTORING SONG PARTS

If you want to re-learn a song part or move on to a new song, the old song part(s) must be cleared first.
To clear/restore a song part:
1. Stop playback of the part by pressing the FOOTSWITCH.
2. Select the part you wish to clear by pressing one of the 3 PART buttons.
3. Press and hold the FOOTSWITCH for approximately 2 seconds or until the STYLE LEDs turn off and the
LEARN LED begins flashing red.
4.
Repeat steps 2 and 3 for any remaining parts you wish to clear.
NOTE: If a part is accidentally cleared, press and hold the FOOTSWITCH again for 2 seconds to restore
the song part.

GUITAR FX

The TRIO provides built-in guitar effects which can be turned on and off using the GUITAR FX button. The button
has 3 states, they are:
• LED Off - The guitar effects are not enabled.
• LED Green - Indicates that a rhythm guitar effect will be used for the 'Learning' and 'Playing' states.
• LED Red - Indicates that a rhythm guitar effect will be used for the 'Learning' state and a lead guitar effect for
the 'Playing' state.
The type of effects added are dependent on the genre selected.
12