Factory Reset; To Change Digital Output Configuration; Formatting Recorder Memory - DigiTech GNX3 User Manual

To change the GNX3's digital output configuration, follow these steps:
1. Press the UTILITY button. The Utility button's LED lights.
2. Press the MODE or DRUMS button, to scroll to the left or right until
Output configuration setup menu). The display begins flashing between
digital output configuration. Note:
factory.
3. Rotate the DATA WHEEL to change the output configuration.
4. Press the EXIT button to exit.

Factory Reset

This function resets the GNX3 to its original factory settings. This procedure erases ALL custom user
presets, utility settings, and re-calibration of the Expression Pedal. The procedure for performing a
Factory Reset is as follows:
NOTE: Performing this function will erase all user-programmed data. Be sure you want to
erase the memory and start fresh before continuing with this procedure. A factory
reset does not erase the internal or external recorder memory.
1. Press the UTILITY button.The Utility button's LED lights.
2. Using the MODE or DRUMS buttons, scroll to the left or right until
3. Rotate the DATA WHEEL clockwise, until the display reads
NOTE: This procedure resets ALL user settings. Rotate the DATA WHEEL
counterclockwise, or press EXIT while NO is blinking in the display to abort.
4. Press the DRUMS button. Yes begins blinking in the display.
5. Press STORE to reset the GNX3. The display returns to the Reset screen.
6. Press EXIT to return to the GNX3 presets.

Formatting Recorder Memory

In the unlikely event the recorder memory (either internal or external) fails to work, it may need to be
reformatted. If internal memory is to be reformatted, remove any memory cards from the GNX3's
Memory Card slot before performing this procedure. If external memory cards are to be reformatted,
insert them into the Memory Card slot before performing this procedure
NOTE: Performing this procedure will erase all recorded information from either internal or
external memory. Be sure you want to erase this memory before continuing with
this procedure.
To reformat the GNX3's recorder memory follow these steps:
1. Begin with the GNX3's power turned off.
2. Press and hold the RECORD button on the GNX3's recorder panel and turn the power on.
3.When the GNX3's main display reads
red.
4. Press the RECORD button to begin the recorder memory formatting procedure. The disply read
formatng
while the procedure is in progress. When completed, the display will return to the preset
screen.
gtr+rec
is the default digital output configuration set from the
format?
, release the RECORD button. It will now be flashing
Other Functions
digi out
is displayed (Digital
digi out
and the selected
RESET
(Reset) is displayed.
NO Yes
(No Yes) and NO is blinking.
71