Adjust The Eq; Adjust The Noise Gate - DigiTech GNX1 User Manual

S F - T
ECTION OUR UTORIAL

Adjust the EQ

The EQ for both the Acoustic Model in the Green channel and our Rectwd HyperModel™ in the Red channel can be
adjusted individually.To do so, press the Effect Select Down button again and the LED on the Equalizer row will light.
The GNX1 will default to the EQ adjustments for the Red Channel and the Display will briefly read EQ RED (EQ
Red). Rotate the Number 1 Knob to adjust the Red Channels Bass enhancement, the Number 2 Knob to select the
center frequency for the Mid-range, the Number 3 Knob to adjust the Mid-range enhancement, the Number 4
Knob to select the center frequency for the Treble, and the Number 5 Knob to adjust the Treble enhancement. Press
the Status button or Amp Footswitch to select the Green Channel's EQ adjustments.The Display will briefly read
EQ GRN (EQ Green) and the same knobs will adjust the same EQ Parameters for the Green Channel.

Adjust the Noise Gate

For our example, we wanted our Noise Gate to open quickly with a relatively weak signal.This type of gate would use
the Silencer™ with a low Threshold and short Attack Time. Press the Amp Footswitch again to select the Red Amp
Channel. Now press the Effect Select Down button and the LED in the Noise Gate row will light. If the Display indi-
cates that the Noise Gate is off (GATOFF), press the Status button until the Display reads GAT ON (Gate On). Rotate
the Number 1 Knob until the Display reads SILNCR (Silencer) as the type of gate. Rotate the Number 2 Knob to
set the Threshold to a value of 20 (this may need further adjustment depending upon your guitar). Rotate the
Number 3 Knob to set the Attack Time value to 0 (fast attack).
29