Getting Started; Making Connections; Mono; Stereo - DigiTech GNX1 User Manual

S O - I
ECTION NE NTRODUCTION

Getting Started

Making Connections

Before connecting the GNX1, make sure that the power to your amplifier is turned off, and that the power switch on
the rear panel of the GNX1 is in the off position.
There are several different connection options available when using the GNX1.You may run mono into an amp or
power amp, stereo into two amps or a stereo power amp, direct into a mixing console, or a combination of these.The
following diagrams show the connections for some of these options.
NOTE: The type of amplification system the GNX1 will be used in should be selected in the Target System Setup
of the Utility menu. See page 34 for more information on selecting the Target System Setup.
Mono Operation
Connect your guitar to the input of the GNX1. Connect the Left output of the GNX1 to the instrument input on your
amplifier, or to the line input of a power amp. Select Mono as the Output mode in the Utility menu. See page 34 for
more on selecting the Output mode.
Stereo Operation
For stereo operation connect the guitar to the input of the GNX1. Connect from the GNX1's Left output to the input
of one amplifier or channel of a power amp. Connect from the Right output of the GNX1 to a second amplifier, or to a
second channel of a power amp. Select Stereo as the Output mode in the Utility menu. See page 34 for more on
selecting the Output mode.
6