Cabinet Tuning/Eq Frequencies; Creating Hypermodels - DigiTech GENESIS3 User Manual

Cabinet Tuning/EQ Frequencies

The resonant frequency of the selected speaker cabinets can also be individually tuned. Cabinet Tuning ranges from
-1™0 (one octave below) to 1™0 (one octave above). You can change the center frequencies of the amp EQ for the
selected amp channel. The procedure for tuning the cabinets and changing the EQ center frequency is as follows:
1. Press and hold the WARP knob down. Release the Warp knob after about 2 seconds when the Display reads
CABTUN (Cabinet Tuning).
2. Rotate the P1 knob to adjust the tuning of the Green Cabinet (GT) and the P5 knob to adjust the tuning of the
Red Cabinet (RT).
3. Rotate the P2 knob to adjust the Bass center frequency (50-300Hz), the P3 knob to adjust the mid-range center
frequency (300-5kHz), and the P4 knob to adjust the treble center frequency (500-8kHz) for the selected channel.
The selected Cabinet's Channel is indicated by the amp parameter LEDs lighting either green or red. Successive
presses of the WARP knob selects either the Green or Red Cabinet for EQ adjustments.
4. Once the desired tuning has been selected for both Green and Red Cabinets, press and hold the WARP knob
again to exit the Cabinet tuning function.

Creating HyperModels™

Once the Green and Red Amp Models and Cabinet types have been selected and the Amp Parameters and Cabinet
Tuning have been adjusted, GeNetX™ technology allows you to do something amazing.The characteristics of each
Amp and Cabinet used in the Green and Red Channels can actually be combined or "Warped" to create a
completely new Amp HyperModel™.The procedure for Warping the Green and Red Amps together is as follows:
1. Rotate the WARP knob to smoothly combine the Amps and Cabinets assigned to the Green and Red Channels
together. Rotating counterclockwise will add more of the Green Channel characteristics, and clockwise will add
more of the Red Channel characteristics.
EDIT
Editing Functions
11