Adjust The Gain, Eq, And Level; Adjust The Noise Gate - DigiTech RP14D User Manual

Adjust the Gain, EQ, and Level

At this point, you should still be on Amp Model Column One (the LED to the left of the words AMP MODEL is on). Press the Parameter
Right button once and the Amp Model Column Two LED will light (to the right of the words Amp Mod). Use the Parameter Up or Down but-
tons until the top vertical LED is on. Following the grid across the Matrix to where the two lit LEDs meet indicates that this is the Amp's Gain
Parameter. Use the Value Up button to increase the gain until it is heavily distorted. Try setting this Parameter to 10.0 or 11.0.
When you select a particular amp type in the Model section of the RP14D, the EQ settings automatically default to give you the settings of the
selected amp type. However you can boost or cut these to suit your taste and in our example Program we wanted some heavy bass. Press the
Parameter Down button again and by following the grid across you will find that this is the Bass Parameter. Use the Value Up or Down button
to set this Parameter to about 10. The final step for the Amp Model is the level of the red Channel.
To get to the Level Parameter, press the Parameter Down button three more time so that the bottom vertical LED is on. You can then use the
Value buttons to set the Volume Level of the Distortion. Try setting this to about 70. You are now finished editing the Amp Model selection.

Adjust the Noise Gate

Now we need to set our Noise Gate Parameters. Press the Parameter Right button to select the Noise Gate column and use the Parameter Up
or Down buttons to select the Noise Gates on/bypass parameter. Use the Value Up button to turn the Gate on. Then press the Parameter
Down button to light the vertical LED second from the top. Following the Grid across the Matrix will indicate that this is reflecting the Gate
Type Parameter. Since we wanted the gate to open immediately rather than fading in, use the Value Down button to set this to gate.
Pressing the Parameter Down button again will take us to the Gate Threshold. Use the Value Up or Down buttons to set this value to -6 which
will allow weaker signals to open the Gate. If this value is too low, adjust it up until the gate closes when you are not playing.
Use the Parameter Left/Right and
Up/Down buttons to light these LEDs
The selected Parameter
is the Amp Gain
Use the Parameter Left/Right and
Up/Down buttons to light these LEDs
The selected Parameter
is the Bass Control
Use the Parameter Left/Right and
Up/Down buttons to light these LEDs
The selected Parameter
is the Level Control
Use the Parameter Right button
to light this LED
Use the Parameter Up/Down buttons
to access these parameters
RP14 UserÕs Guide
Use Value buttons to select
10 as the Gain Value
1 0
Use Value buttons to select
10 as the Bass Value
1 0
Use Value buttons to select
70 as the Level Value
7 0
Use Value buttons to turn the Gate on
set the Type to gate, and Thresh to 3
g a t e
Section Four - Tutorial
23