Xerox 2101 User Manual page 21

Laser Safety
Use of controls, adjustments, or procedures
other than those specified in this
documentation may result in a hazardous
exposure to laser radiation.
This equipment complies with international
Maintenance Safety
Do not attempt any maintenance procedure that
is not specifically described in the
documentation that is supplied with your
copier/printer.
• Do not use aerosol cleaners. The use of
supplies that are not approved may cause
poor performance of the copier/printer, and
could create a dangerous condition.
• Use the supplies and cleaning materials only as
directed in this manual. Keep all of these
Operational Safety
Your Xerox equipment and supplies were
designed and tested to meet strict safety require-
ments. These include safety agency examina-
tion, approval, and compliance with established
environmental standards.
Your attention to the following safety guidelines
will help ensure the continued safe operation of
your copier/printer:
• Use the materials and supplies specifically
designed for your copier/printer. The use of
unsuitable materials may result in poor
performance of the machine and possibly a
hazardous situation.
• Follow all warnings and instructions that are
marked on or supplied with the machine.
• Place the machine in a room that provides
adequate space for ventilation and servicing.
safety standards. With specific regard to laser
safety, the equipment complies with
performance standards for laser products set
by government, national, and international
agencies as a Class 1 laser product. It does
not emit hazardous light, as the beam is totally
enclosed during all phases of customer
operation and maintenance.
materials out of the reach of children.
• Do not remove the covers or guards that are
fastened with screws. There are no parts
behind these covers that you can maintain or
service.
Do not perform any maintenance procedures
unless you have been trained to do them by a
Xerox representative or unless a procedure is
specifically described in one of the copier/
printer manuals.
• Place the machine on a level, solid surface
(not on a thick pile carpet) that has adequate
strength to support the weight of the machine.
• Do not attempt to move the machine. A
leveling device that was lowered when your
machine was installed may damage the carpet
or floor.
• Do not locate the machine near a heat source.
• Do not locate the machine in direct sunlight
• Do not locate the machine in line with the cold
air flow from an air conditioning system.
• Do not place containers of coffee or other
liquid on the machine.
• Do not block or cover the slots and openings
on the machine. Without adequate ventilation,
the machine may overheat.
• Do not attempt to override any electrical or
mechanical interlock devices.
Safety Notes
.
xix