Gaggia KIII-D Operating Instructions Manual page 37

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 20
Trouble
The machine will not operate when
the coffee selection buttons are
pressed
No coffee comes out
Coffee comes out slowly, in drips
The amount of coffee dispensed is
inadequate
Coffee does not taste good
Froth is not creamy enough, or the
froth-making process takes too
long
The machine will not dispense
steam
The selection buttons for caffè
lungo and cream coffee are
blinking
DISPOSAL
This product complies with EU Directive 00/9/EC.
The symbol
on the product or on its packaging indicates that this product may not
be treated as household waste. Instead it shall be handed over to the applicable collection
point for the recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product. For more detailed information about recycling
of this product, please contact your local city office, your household waste disposal service
or the shop where you purchased the product.
Solution
The lever was not properly pulled down. Pull down the
lever.
There is no water in the tank. Fill it up
Scale has built up in the machine. De-scale the machine.
• You have pressed the wrong button (if the "caffè
espresso" button is pressed, the machine will only
dispense 0 ml / .05 ounces of water). Press the right
one.
•The amount of water was improperly set. Set the amount
of water as described in the section "User settings
according to user taste"
• There is a used capsule in the machine. Each capsule
can only be used once. Use a new one.
•The amount of water was improperly set. Set the amount
of water as described in the section "User settings
according to user taste".
• The milk used is too hot, off, or contains an excessively
high percentage of fat. Use fresh cold milk (max..5 %
fat)
• The steam wand is dirty. Clean it.
• Scale has built up in the machine. De-scale the
machine.
• The water tank is empty. Fill it!
• The machine has not reached the required temperature.
Wait till the steam button illuminates steadily
An error has occurred. Turn off the machine and then
turn it on again.


Advertisement

Table of Contents
loading

Table of Contents