Installing The Pedalboard (Els-01X) - Yamaha Electone STAGEA ELS-01C Owner's Manual

Installing the Pedalboard (ELS-01X)

If you are using the ELS-01X, uninstall the pedalboard before moving the Electone and install it again after moving.
Installing the Pedalboard
Precautions
Before installing/uninstalling, turn the power of
the Electone off.
Be sure to install the pedalboard with two or
more people.
Take care not to drop the pedalboard or to
pinch your finger(s).
1
Guide the pedal unit carefully into the side
frame as shown, fitting the metal protrusion
into the hook on the frame.
Take care not to pinch the pedalboard cord and/or
the output cord between the pedal unit and side
frame.
14
220 ELS-01/01C/01X Owner's Manual
2
Securely connect the output cord to the left
side of the pedalboard.
Also, connect the pedalboard cord by
fastening to the nut.
2
NOTE
When disconnecting the output cord, pull it while firmly holding
the metal edge.
3
Attach the side covers.
Match the hole of the side cover to the projection of
the pedal unit, then slide the cover back so that it fits
in place.
To uninstall the pedalboard, reverse the procedure.
1