Installing Cage Nuts In The Rack Frame - HP 195294-001 - ProLiant - ML370R Setup And Installation Manual

3. Place the template against the vertical rails so that the sides of the template are
aligned with the sides of the rack.
NOTE: Tick marks on the rack's vertical rails mark off U-spaces in the rack configuration
and help to maintain the proper alignment.
4. Use a pencil to mark the locations on the outside of the front of the rack where
the spring-load rack rails must be inserted.
5. Place additional pencil marks on the rack at the top edge of the template to align
the template for the next component.
6. Move to the rear of the rack and turn the template over to use the backside of the
template.
7. Repeat steps 2 through 5 with the back of the template on the rear of the rack.
IMPORTANT: On the rear of the rack, make pencil marks on the inside of the vertical
rails. These markings guide you in installing spring-load rack rails into the interior of the
rack frame.
After marking the front and rear of the rack, remove the template from the rack and
prepare the rack for installation. Store the template for future use.

Installing Cage Nuts in the Rack Frame

After marking the positions for the fasteners in both the front and back of the rack,
insert cage nuts on the inside of the rails at the marked locations. The cage nuts are
included in the hardware kit supplied with the rack.
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
Installing the Rack Server
4-5