Boot Options; System Maintenance Menu - HP 195294-001 - ProLiant - ML370R Setup And Installation Manual

By default, the auto-configuration process configures the system for the Microsoft
Windows 2000 operating system, as shown in Figure 7-1. To change any default
settings in the auto-configuration process, such as the settings for language, operating
system, and primary boot controller, run RBSU by pressing the F9 key when
prompted. After the settings are selected according to your preference, exit RBSU
and reboot the server. For more information about this process, refer to the HP
ROM-Based Setup Utility User Guide.

Boot Options

After the auto-configuration process completes, or after the server reboots upon exit
from RBSU, the Power-On Self-Test (POST) sequence runs, and then the boot option
screen is displayed. This screen is visible for several seconds before the system
attempts to boot from either a bootable CD or the hard drive. During this time, the
menu on the screen allows you to install an operating system, make changes to the
server configuration in RBSU, or run the System Maintenance Menu. For detailed
information about these options, refer to the HP ROM-Based Setup Utility User
Guide.

System Maintenance Menu

The System Maintenance Menu provides access to server diagnostics, RBSU, and
the Inspect utility. Embedded in the system ROM, the menu feature replaces the
legacy system-partition functionality supported on some servers.
To access the System Maintenance Menu, press the F10 key when prompted from
the boot option screen. For more information on using the features of the System
Maintenance Menu, refer to the HP ROM-Based Setup Utility User Guide.
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
Server Configuration and Utilities
7-21