Connecting The Power Cord And Peripheral Devices; Power Cord Guidelines - HP 195294-001 - ProLiant - ML370R Setup And Installation Manual

Connecting the Power Cord and Peripheral Devices

After all internal hardware options have been installed in the server, connect external
power supplies and peripheral devices to the connectors located on the rear panel of
the server. Icons on the back of the server identify the function of each connector.
WARNING: To reduce the risk of electrical shock or fire, do not plug
telecommunications/telephone connectors into the NIC receptacles.
IMPORTANT: If the Remote Insight Lights-Out Edition II (RILOE II) board is installed in the
server, be sure that you connect the video cable to the video connector on the rear of the
RILOE II board. The standard video connector on the server rear panel is not used when the
RILOE II board is installed.
Refer to "Rear Panel Components" in Chapter 3 to identify connectors on the rear
panel of the tower server.

Power Cord Guidelines

Connect the power cords provided with the server or hot-plug power supply option to
each AC power supply and use the power cord retaining clips to secure the AC power
cords. Leave a service loop for the plug to prevent the plug from accidentally being
disengaged. Refer to Chapter 4, "Installing the Rack Server," for additional power
cord instructions.
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
Installing the Tower Server
5-3