HP 195294-001 - ProLiant - ML370R Setup And Installation Manual page 220

Troubleshooting
Table D-6: Is the Monitor Displaying Information?
Answer Possible Reasons
No The monitor may not have power.
Video may not be connected
properly.
Nonvolatile RAM (NVRAM) may
be corrupted.
The system ROM and redundant
ROM may be corrupted.
The system board may need to
be replaced.
Yes Video is available for diagnosis. Determine the next action by observing POST progress
and error messages. Refer to the Servers Troubleshooting Guide for a complete
description of each POST error message.
D-12
Possible Solutions
Be sure that the monitor power cord is plugged in
and that the monitor power button has been
pressed.
If a video card is installed, be sure that the video
cable is properly connected.
If a Remote Insight Lights-Out Edition expansion
board is installed, be sure that the video cable is
connected to the video connector on this
expansion board.
Check the video connections. Refer to the Servers
Troubleshooting Guide for information about video
problems.
Clear NVRAM. Refer to Appendix E for the correct
switch setting.
Are there any audible indicators, such as a series
of beeps? A series of beeps is the audible signal
indicating the presence of a POST error message.
Refer to the Servers Troubleshooting Guide for a
complete description of each beep sequence and
the corresponding error messages.
If these steps do not solve the problem, contact
your authorized service provider for assistance.
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide