HP 195294-001 - ProLiant - ML370R Setup And Installation Manual page 115
Hp proliant ml370 generation 3 setup and installation guide
Hide thumbs
Also See for 195294-001 - ProLiant - ML370R:
- Reference manual (138 pages) ,
- Configuration manual (2 pages) ,
- Installation instructions manual (15 pages)
Table of Contents
Advertisement
Installing Hardware Options
7. Use the power cord management clip on the power supply to secure the cord and
form a service loop.
8. Press up on the lower part of the clip to close and lock.
Figure 3-60: Using a management clip to secure the
power cord
9. Connect the power cord to the AC power source and observe the power supply
LED on the unit to be sure that it is green, indicating the power supply is
properly powered and active.
IMPORTANT: For maximum server availability, be sure that the two power supplies are
powered by separate AC power sources.
NOTE: If you remove or replace the primary hot-plug power supply, use the Torx T-15
tool provided with the server to remove the shipping screws from the upper right and left
corners of the power supply unit.
For additional information about power supply LEDs, refer to Appendix E, "LED
Indicators and Switches."
3-70
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
Advertisement
Table of Contents
