HP 195294-001 - ProLiant - ML370R Setup And Installation Manual page 212

Troubleshooting
7. Check the server for the following normal power-up sequence to be sure that the
server meets the minimal hardware requirements and is powered up during
normal operations:
a. The front panel Power On/Standby LED turns from amber (standby) to solid
green (on).
b. The fans start up.
c. The external and internal system health LEDs turn solid green.
8. Check the monitor for the following messages to be sure that the server meets the
minimal hardware requirements and is powered up during normal operations:
a. ProLiant logo
b. Memory test
c. BIOS information
d. Copyright information
e. Processor initialization
NOTE: The remaining items in this list pertain to option ROMs. The messages for these
items appear only if they are installed and enabled.
f.
Multi-initiator configuration
IMPORTANT: Select the multi-initiator configuration utility (CTRL-A) only to support HP
or Compaq branded storage and clustering options. Refer to Chapter 7, "Server
Configuration and Utilities," for additional information.
g. SCSI devices
h. RAID initialization (if a RAID controller is installed)
i.
PXE initialization
9. The operating system loads to complete the boot process.
If the server completes POST and attempts to load the operating system, go to the
"Problems After Initial Boot" section in this appendix.
D-4 HP ProLiant ML370 Generation 3 Server Setup and Installation Guide