Configuring Https; Table 3-4. Https Support - SMC Networks 8748L2 Management Manual

C
ONFIGURING THE

Configuring HTTPS

You can configure the switch to enable the Secure Hypertext Transfer
Protocol (HTTPS) over the Secure Socket Layer (SSL), providing secure
access (i.e., an encrypted connection) to the switch's web interface.
Command Usage
• Both the HTTP and HTTPS service can be enabled independently on
the switch. However, you cannot configure both services to use the
same UDP port.
• If you enable HTTPS, you must indicate this in the URL that you
specify in your browser: https://device[:port_number]
• When you start HTTPS, the connection is established in this way:
- The client authenticates the server using the server's digital
certificate.
- The client and server negotiate a set of security protocols to use for
the connection.
- The client and server generate session keys for encrypting and
decrypting data.
• The client and server establish a secure encrypted connection.
A padlock icon should appear in the status bar for Internet Explorer
5.x or above and Netscape Navigator 6.2 or above.
• The following web browsers and operating systems currently support
HTTPS:
Web Browser
Internet Explorer 5.0 or later
Netscape Navigator 6.2 or later
• To specify a secure-site certificate, see "Replacing the Default
Secure-site Certificate" on page 3-49.
3-48
S
WITCH

Table 3-4. HTTPS Support

Operating System
Windows 98,Windows NT (with
service pack 6a), Windows 2000,
Windows XP
Windows 98,Windows NT (with
service pack 6a), Windows 2000,
Windows XP, Solaris 2.6