Enabling Snmp Management Access - SMC Networks 8748L2 Management Manual

I C
NITIAL ONFIGURATION
1. From the Global Configuration mode prompt, type "interface vlan 1"
to access the interface-configuration mode. Press <Enter>.
2. At the interface-configuration mode prompt, use one of the following
commands:
•
•
3. Type "end" to return to the Privileged Exec mode. Press <Enter>.
4. Type "ip dhcp restart client" to begin broadcasting service requests.
Press <Enter>.
5. Wait a few minutes, and then check the IP configuration settings by
typing the "show ip interface" command. Press <Enter>.
6. Then save your configuration changes by typing "copy running-config
startup-config." Enter the startup file name and press <Enter>.
Console(config)#interface vlan 1
Console(config-if)#ip address dhcp
Console(config-if)#end
Console#ip dhcp restart client
Console#show ip interface
IP address and netmask: 192.168.1.54 255.255.255.0 on VLAN 1,
and address mode: User specified.
Console#copy running-config startup-config
Startup configuration file name []: startup
\Write to FLASH Programming.
\Write to FLASH finish.
Success.

Enabling SNMP Management Access

The switch can be configured to accept management commands from
Simple Network Management Protocol (SNMP) applications such as
SMC EliteView or HP OpenView. You can configure the switch to
(1) respond to SNMP requests or (2) generate SNMP traps.
2-8
To obtain IP settings via DHCP, type "ip address dhcp" and press
<Enter>.
To obtain IP settings via BOOTP, type "ip address bootp" and
press <Enter>.