Boot System - SMC Networks 8748L2 Management Manual

Command Mode
Privileged Exec
Example
This example shows the information displayed by the whichboot
command. See the table under the dir command for a description of the
file information displayed by this command.
Console#whichboot
-------------------------------- ----------------------- ------- -----------
Unit1:
Console#

boot system

This command specifies the image used to start up the system.
Syntax
boot system [unit:] {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM.
• config* - Configuration file.
• opcode* - Run-time operation code.
• filename - Name of the configuration file or image name.
• unit* - Stack unit. (Range: 1-8)
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified file type.
• If the file contains an error, it cannot be set as the default file.
file name
diag_0060
run_0200
startup
F /F
LASH
file type startup size (byte)
Boot-Rom image
Operation Code
Config File
C
ILE OMMANDS
Y 111360
Y 1083008
Y 2710
4-89