Ethernet Interface Commands; Interface Ethernet - SMC Networks 2555W-AG2 User Manual

Ethernet Interface Commands

The commands described in this section configure connection parameters for the
Ethernet port and wireless interface.
Command

interface ethernet

dns primary- server
dns secondary- server
ip address
ip dhcp
speed-duplex
shutdown
show interface ethernet
interface ethernet
This command enters Ethernet interface configuration mode.
Default Setting
None
Command Mode
Global Configuration
Example
To specify the 10/100Base-TX network interface, enter the following command:
Enterprise AP(config)#interface ethernet
Enterprise AP(if-ethernet)#
Table 7-16. Ethernet Interface Commands
Function
Enters Ethernet interface configuration mode
Specifies the primary name server
Specifies the secondary name server
Sets the IP address for the Ethernet interface
Submits a DHCP request for an IP address
Configures speed and duplex operation on the
Ethernet interface
Disables the Ethernet interface
Shows the status for the Ethernet interface
Ethernet Interface Commands
Mode
GC
IC-E
IC-E
IC-E
IC-E
IC-E
IC-E
Exec
7
Page
7-87
7-88
7-88
7-88
7-89
7-90
7-91
7-91
7-87