Table of Contents
Advertisement
Prestige 1400 WAN Router with Integrated Ethernet Switch
You can perform the backup either through FTP or TFTP (preferred methods as they are faster) or through the RS-
232 console port (if the network is down). For backup via the console port any serial communications program
should work fine; however, you must use the XMODEM protocol to perform the download/upload.
FTP or TFTP are the preferred methods for backing up the current Prestige
configuration to your workstation since FTP or TFTP is faster.
Ready to back up Configuration via Xmodem.
Do you want to continue (Y/N):
Figure 14-3 Menu 24.5 - Menu 24.5 as seen using the Console Port
Go to menu 24.5.
Step 1.
Press "Y" to indicate that you want to continue. The following procedure is for the HyperTerminal
Step 2.
program. The procedure for other serial communications programs should be similar.
Click Transfer in the HyperTerminal menu bar, then Receive File from the drop-down menu to display
Step 3.
the following screen. Follow the instructions as shown in the next screen.
Finally,
press
Receive.
After a successful backup, you will see the following screen.
Step 4.
** Backup Configuration completed. OK.
### Hit any key to continue.###
14.3
Restore Configuration
Option 6 from Menu 24 - System Maintenance allows you to restore the current workstation backup configuration
to your Prestige.
14.3.1 Restore using FTP
To transfer your current workstation configuration to your Prestige, follow the instructions as shown in the
following screen. See also the FTP example later in this chapter. For details on FTP commands, please consult the
documentation of your FTP client program.
14-4
Menu 24.5 – Backup Configuration
Figure 14-4 Backup Example Using HyperTerminal
Figure 14-5 Successful Backup Confirmation Screen
Enter where you want to
place the configuration file
on your computer.
Choose the
Xmodem
Protocol.
Configuration & Firmware Maintenance
Advertisement
Table of Contents
Troubleshooting
