Installing And Adjusting The Cinewide Anamorphic Lens; Attach Lens Mounting Assembly To Lens Motor Carriage Plate; (Cinewide With Autoscope) Or Base Plate (Fixed Cinewide) - Runco VIDEO XTREME VX-22D Installation & Operation Manual

If you are installing a VX-22d/CineWide or VX-22d/CineWide with AutoScope, proceed as
follows to install and adjust the anamorphic lens.
It is extremely important that the primary lens is properly
Note
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
The VX-22d Anamorphic lens mount kit consists of everything shown in Figure 3-19.
Some components shipped with your projector may differ slightly from what is shown in
these instructions. If any items are missing or damaged, please contact your Runco dealer
or Runco Customer Service at (800) 23-RUNCO.
1
10 Anamorphic Lens
Set Screw
9 Pitch Adjustment
T-Nut (2x)
Yaw/X Adjustment
8
Lever (2x)
Figure 3-19. VX-22d Anamorphic Lens Mounting Assembly - Exploded View
1. Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the
Anamorphic Lens Holder (item #5).
Runco VX-22d Installation/Operation Manual
Lens Adapter Ring and
Mounting Screws (3x)
2 Pitch Adjustment Yoke for Lens
3
Height/Y Adjustment
T-Screw and Washer
(2x)
4
Pitch Adjustment
T-Screw and
Washer (2x)
5
Anamorphic Lens
Holder
6 1/4-20 Hex Bolt (2x)
and Washer (2x)
7
AutoScope Carriage Plate or
Fixed CineWide Base Plate
41
Installation
3.11
Installing and
Adjusting the
CineWide Anamorphic
Lens
Attach Lens Mounting
Assembly to Lens Motor
Carriage Plate (CineWide
with AutoScope) or Base
Plate (fixed CineWide)