Installing An Internal 3.5-Inch Hard Drive - HP Pro 3000 SFF Maintenance And Service Manual

Installing an Internal 3.5-inch Hard Drive

1. Follow the steps in
hard drive.
2. Install the guide screw in the middle hole on the right side of the drive.
NOTE:
the new drive.
Figure 7-36
3. Align the guide screw on the drive with the slot on the chassis. Slide the hard drive into the drive
bay from the back until the two screw holes on the left side of the drive line up with the two
screw holes on the left side of the drive cage (1).
4. Secure the hard drive by fastening two retainer screws through the holes in the left side of the
drive cage into the corresponding holes in the left side of the hard drive (2).
Figure 7-37
NOTE:
cage. The 6-32 retainer screws for hard drives are silver.
Removing an Internal 3.5-inch Hard Drive on page 113
When replacing a hard drive, remove the guide screws from the old drive for use with
Installing the Guide Screw in the Hard Drive
Installing an Internal Hard Drive
Extra retainer screws are provided on the front of the chassis under the hard drive
to remove the old
Drives 115