HP Pro 3000 SFF Maintenance And Service Manual page 76

5. Attach the two screws that secure the hard disk drive cage to the chassis.
Figure 6-32
6. If installing a new drive, connect the opposite end of the data cable to the appropriate system
board connector. If your system has only one SATA hard drive, you must connect the hard drive
data cable to the dark blue connector to avoid any hard drive performance problems. If you are
adding a second hard drive, connect the data cable to the next available (unpopulated) SATA
connector on the system board.
NOTE:
cable to the dark blue SATA on the system board to avoid any hard drive performance problems.
If you are adding a second hard drive, connect the data cable to the next available (unpopulated)
SATA connector on the system board.
7. Replace the computer access panel.
8. Reconnect the power cord and any external devices, then turn on the computer.
9. Lock any security devices that were disengaged when the access panel was removed.
66 Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
Securing the Hard Drive Cage
If your system has only one SATA hard drive, you must connect the hard drive data