HP Pro 3000 SFF Maintenance And Service Manual page 191

Table D-3 Specifications – HP Pro 3000/3080 Small Form Factor (continued)
Power Output
Rated Input Current (maximum)
This system utilizes a passive power factor corrected power supply. The power factor correction is present in the 230V
1
operating mode only. This allows the system to pass the CE mark requirements for use in the countries of the European
Union. This supply requires the use of an input voltage range select switch.
Table D-4 Specifications – HP Pro 3010 Small Form Factor
Desktop Dimensions
Height
Width
Depth
Approximate Weight
Temperature Range
Operating
Nonoperating
Relative Humidity (noncondensing)
Operating
Nonoperating (38.7°C max wet bulb)
Maximum Altitude (unpressurized)
Operating
Nonoperating
NOTE: Operating temperature is derated 1.0° C per 300 m (1000 ft) to 3000 m (10,000 ft) above sea level; no
direct sustained sunlight. Maximum rate of change is 10° C/Hr. The upper limit may be limited by the type and
number of options installed.
Heat Dissipation
Maximum
Typical (idle)
Power Supply
Operating Voltage Range
Rated Voltage Range
Rated Line Frequency
Power Output
Rated Input Current (maximum)
This system utilizes a passive power factor corrected power supply. The power factor correction is present in the 230V
1
operating mode only. This allows the system to pass the CE mark requirements for use in the countries of the European
Union. This supply requires the use of an input voltage range select switch.
1
1
300 W 300 W
8A @ 100 VAC 4A @ 200 VAC
3.98 in 101 mm
13.35 in 339 mm
15.24 in 387 mm
14.95 lb 6.78 kg
50° to 95°F 10° to 35°C
-22° to 140°F -30° to 60°C
10-90% 10-90%
5-95% 5-95%
10,000 ft 3048 m
30,000 ft 9144 m
1575 BTU/hr 397 kg-cal/hr
307 BTU/hr 77 kg-cal/hr
115V 230V
90-132 VAC 180-264 VAC
100-127 VAC 200-240 VAC
50-60 Hz 50-60 Hz
300 W 300 W
8A @ 100 VAC 4A @ 200 VAC
Small Form Factor 181