Removing An Internal 3.5-Inch Hard Drive - HP Pro 3000 SFF Maintenance And Service Manual

Removing an Internal 3.5-inch Hard Drive

NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so
that you can transfer the data to the new hard drive. Also, if you are replacing the primary hard drive,
make sure you have created a Recovery Disc Set to restore the operating system, software drivers,
and any software applications that were preinstalled on the computer. If you do not have this CD set,
select Start > HP Backup and Recovery and create it now.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the power cable (1) and data cable (2) from the back of the hard drive.
Figure 7-33
(Access Panel on page
(Front Bezel on page
Disconnecting the Hard Drive Cables
(Preparation for Disassembly on page
85).
86).
84).
Drives 113