Operating Denon Audio Components; Setting The Preset Memory Function - Denon DRA-297 Operating Instructions Manual

ENGLISH
4.R:ef~rring
to. the included list of preset' codes,. press
[NIUMI:BER]·to input the preset code (a 3-digit number)
for the manufacturer of the component whose signals
youwant·to store in the memory.
5To' store ,the codes of another .component in the
memory, repeat steps 1 to 4.
• The signals for the pressed buttons are emitted while setting the
preset memory. To avoid accidental operation, cover the remote
control unit's transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes listed in
the list of preset codes.
• Some manufacturers use more than one type of remote control
code. Refer to the included list of preset codes to change the
number and verify correct operation. .
• The preset memory can be set for one component only among the
following: CD/iPod, DBS/CABLE and CD-RITAPE.
Operating DENON audio components
Setting the preset memory function
det , ponen eratil1g ctions.
*
his remote control is compatible with a wide range of
infrared controlled components, it may be the . case that some
component models cannot be operated with this remote control.
Operating the remote control unit
• DENON and other makes of components can be operated by setting
the preset memory.
• This remote control unit can be used to operate components of
other manufacturers without using the learning function by
registering the manufacturer of the component as shown in the list
of preset codes
(!&'
End of this manual).
• Operation is not possible for some models.
[TV POWER ON] [DVDNDP
POWER ON]
[NUMBER]
(0 - 9, +10)
[MODE SELECTOR 1]
----:...:....rmmO;:::""-CO'I~~~--
[MODE SELECTOR 2]
1
Set
lM.ODE SELECTOR
1] to
"A"
or
"B".
*
Set to the A· side for· the CD/iPod, TV, DBS/CABLE or DVD
position, andtotheB s' f the CD-
E
or VCR position.
19
ENGLISH