Other Functions - Yamaha CL1 Owner's Manual

Synchronizing CL Editor
When CL Editor starts up, the parameter settings on the console and the parameter settings in CL Editor may be different.
Therefore, you must first match the parameter settings on the console with those in CL Editor. This operation is called
"synchronization. " Follow the steps below to synchronize CL Editor.
1 Select [Synchronization], then [Re-synchronize].
The following window opens.
If CL Editor is in the offline status the
NOTE
[Re-synchronize] function is not available.
2 Select whether you want to transfer your settings
to CL Editor, or vice versa.
At this time, the All Libraries option determines whether or not Library data is synchronized.
Console ➔ PC:
Transfers the current parameter settings of your console to the CL Editor.
PC ➔ Console:
Transfers the current parameter settings in CL Editor to your console.
3 Click [OK].
Do not operate the console while synchronization is in progress.
Offline Edit Function
If you do not want to synchronize your console with CL Editor, select [Offline Edit] from the [Synchronization] menu. To
apply your off-line edits to your console, select [Re-Synchronize] from the [Synchronization] with the PC -> Console
option to synchronize the console with CL Editor.
The Offline Edit function is also activated when you click the [ONLINE]/[OFFLINE] button in the Master window.
Some effect parameters in the console change their displayed values depending on the sampling fre-
NOTE
quency. If you switch CL Editor from OFFLINE to ONLINE, displayed parameter values may change
because CL Editor loads the sampling frequency from the console and updates the display.

Other Functions

❏ Resetting to the default value (Ctrl( )+click)
Move the cursor to a control or a parameter value, then hold down the <Ctrl>(< >) key and click the mouse button to
reset the value to the default (e.g., to reset a pan setting to Center).
However, the channel faders and the send knobs and bar graphs can be set to –∞ regardless of the default value.
❏ Ctrl( )+Shift+Click
Move the mouse cursor to a channel fader or to a send knob or bar graph, and click while holding down the
<Ctrl>(< >) key and <Shift> key to set the nominal value regardless of the default value.
8 CL Editor Owner's Manual