Yamaha CL1 Owner's Manual page 38

❏ TO STEREO/MONO
Here you can specify how the signal will be sent from the MIX channel to the STEREO bus/MONO bus.
MODE
• ST/MONO button
When this button is on, the signal will be sent to the STEREO bus and independently to the MONO bus.
[for MONO mix channel]
PAN (BALANCE for
STEREO bus)
ST
M(C)
• LCR button
When this button is on, the signal will be sent to the L/C/R buses which work in conjunction with each other.
[for MONO mix channel]
PAN (BALANCE for
STEREO bus)
CSR (Center Side Ratio)
The PAN knob adjusts the panning of the signal sent from the MIX channel to the STE-
REO bus L/R channels. You can set this to the center position by holding down the
<Ctrl>(< >) key of the computer keyboard and clicking the knob. If the selected MIX bus
is used as a stereo bus, this will be the BALANCE. The BALANCE knob adjusts the bal-
ance of the signal that is sent from the MIX channel to the STEREO bus L/R channels.
Switches the signal sent from the MIX channel to the STEREO bus on/off.
Switches the signal sent from the MIX channel to the MONO bus on/off.
The PAN knob adjusts the panning of the signal that is sent from the MIX channel to each
of the L/C/R channels. You can set this to the center position by holding down the
<Ctrl>(< >) key of the computer keyboard and clicking the knob. If the selected MIX bus
is used as a stereo bus, this will be the BALANCE. The BALANCE knob adjusts the bal-
ance of the signal that is sent from the MIX channel to the STEREO bus L/R channels.
Adjusts the proportion of the CENTER channel level relative to the STEREO bus L/R in a
range of 0–100%.
38
[for STEREO mix channel]
[for STEREO mix channel]
CL Editor Owner's Manual