Effect Parameters; Mix Balance - Yamaha CL1 Owner's Manual

0
Output meter
Indicates the level of the signal being output from the internal effect.
A
Parameter display select button
If "REV-X HALL, " "REV-X ROOM, " "REV-X PLATE, " or VCM effect is selected as the effect type, this button switches
between the standard parameter screen and a dedicated GUI screen.
B
C
D
E
F
F
PLAY/REC (Play/Record) buttons
If "FREEZE" is selected as the effect type, you can use these buttons to record and play back the signal being input to
the effect.
G

Effect parameters

This area shows the effect parameters and knobs for the currently selected effect type. It also shows the GUI screen that
are specific to the following each effect type: REV-X HALL, REV-X ROOM, REV-X PLATE, COMP276, COMP276S,
COMP260, COMP260S, EQUALIZER601, and OPENDECK.
B

MIX BALANCE

Adjusts the balance of the effect sound relative to the original sound. 0 (%) outputs only the
original sound, and 100 (%) outputs only the effect sound.
C
TEMPO
If a tempo-type or modulation-type effect is selected, this allows you to adjust time-related
parameters such as DELAY (delay time) and FREQ. (modulation speed.)
To set the value of the TEMPO parameter, you can either input the BPM (Beats Per Minute)
in the numerical box, or repeatedly click the TAP TEMPO button at the desired tempo.
If the MIDI CLK button is on, the TEMPO parameter value will synchronize to the MIDI
timing clock being received from the MIDI port.
D
SOLO
If "M.BAND DYNA" or "M.BAND COMP" are selected as the effect type, these buttons
allow you to monitor only the specified band from the three bands HIGH, MID, and LOW.
E
GR meter (Gain Reduction meter)
If "M.BAND DYNA" or "M.BAND COMP" are selected as the effect type, this indicates the
gain reduction amount for the H (HIGH), M (MID), and L (LOW) bands.
G
62 CL Editor Owner's Manual