Yamaha CL1 Owner's Manual page 27

❏ TO MIX/TO MATRIX SEND
1
2
3
4
1
MIX/MATRIX send level
This adjusts the send level of the signal sent from the input channel to VARI-type MIX bus and MATRIX bus. The cur-
rent value is shown in the numerical box immediately below.
2
PRE (PRE on/off)
This selects PRE or POST as the point from which the signal is sent from the input channel to the MIX bus and
MATRIX bus. The point will be PRE EQ or PRE FADER when this is on, and POST FADER when this is off. The PRE
EQ/FADER setting can be specified in the Mixer Setup dialogbox.
Right-click the PRE button to display a context-sensitive menu that will enable you to specify ALL PRE,
NOTE
ALL POST, or other options.
3
ON (MIX/MATRIX send on/off)
This is an on/off switch for the signal sent from the input channel to the MIX bus and MATRIX bus.
HINT
• When MIX buses or MATRIX
buses are being used in stereo,
the odd-numbered knob will be
PAN or BAL (BALANCE.) If the
INPUT CH is selected, the odd-
numbered knob will be always
PAN. If the ST IN is selected, the odd-numbered will be PAN or BAL.
You can switch between Pan and Balance in the TO STEREO/MONO section.
• If the FIXED type is selected for the MIX bus, only the ON button is valid.
• The stereo/mono setting and the VARI type/FIXED type setting can be
made in the Mixer Setup dialogbox.
4
Channel name
This section indicates the name of the MIX channel or MATRIX channel.
❏ HA/D.GAIN/HPF/Ø/GC
1 2
5 4
3
HPF (High Pass Filter)
Use the [ON] button at the right to switch the high-pass filter on/off. You can use the knob at left to adjust the cutoff
frequency. The current value is shown in the numerical box below the knob. An indication of "H" will appear on the
EQ graph of the equalizer.
4
Ø (Phase)
Inverts the phase polarity of the signal after AD conversion.
5
GC (Gain Compensation)
This is an on/off switch for the head amp's analog gain correction. If you want to share the same I/O rack with the mul-
tiple CL consoles, this function maintains the audio signal at a specific level throughout the network. This button will
be displayed only if the DANTE ports have been patched.
Knob of odd-numbered side
1
HA (HA analog gain)
3
Adjusts the analog gain of the internal head amp or of the external
head amp patched to the input channel. The current value is shown
in the numerical box below the knob. You can set this to the default
value (– 6dB) by holding down the <Ctrl>(< >) key and clicking
the knob. You can also use the [48V] button to switch phantom
power on/off.
2
D.GAIN (Digital Gain)
Drag the knob in the screen to adjust the digital gain (input gain) of
the input channel.
1
2
3
4
27
Knob of odd-numbered side
CL Editor Owner's Manual