Yamaha CL1 Owner's Manual page 21

2
3
4
5
6
7
8
9
0
A
2
STEREO (Send levels from the STEREO channels to the MATRIX
bus)
Here you can view and edit the send levels of the signals sent from the STEREO channels to
the MATRIX bus. While you drag the bar graph, the send level is shown in the numerical
display area immediately below. The method of operation and the meaning of the display
5
are the same as for (
3
EQ (Equalizer)
Switches the EQ on/off. The graph immediately below the button shows the approximate
response of the EQ. This is the same as the equalizer for INPUT CH (➥ p.13.)
4
DYNA1 (Dynamics 1)
Switches the dynamics processor on/off. This is the same as the dynamics 2 for INPUT CH
(➥ p.13.)
5
INSERT
Enables/disables the insert-in.
6
SEL (Channel selection)
Selects the MATRIX channel for which you want to make settings.
7
CUE
This button cue-monitors the signal of the MATRIX channel.
If the Channel Select/Sends On Fader checkbox in the System Setup dia-
NOTE
log box is not checked, the [CUE] button will be hidden in the screen.
8
ON
This switches the MATRIX channel on/off.
If the corresponding channel is off, the fader will be grayed out.
9
Fader
This adjusts the output level of the MATRIX channel. The current fader value is shown in
the numeric box immediately below the fader.
The numbers and alphabetical letters at the right of the fader indicate the mute groups to
which that channel belongs, and show the Recall Safe and Mute Safe status of the channel.
(For the significance of the numbers and alphabetical letters, see ➥ p.18.)
Click the indicator area at the right side of the fader to switch between 3
NOTE
indicators (mute group indicator, mute safe/recall safe indicator, level
meter).
0
Channel number
Indicates the number of the MATRIX channel. You can double-click this number to open
the Selected Channel window for this channel. If you hold down the <Ctrl>(< >) key of
your computer keyboard and double-click this, the Selected Channel window will open as
an additional view.
A
Channel name
This is a text box that displays the channel name. You can also edit the channel name in this
text box.
) MATRIX in the MIX window (➥ p.18.)
21 CL Editor Owner's Manual