If A Mix Channel Is Selected - Yamaha CL1 Owner's Manual

If a MIX channel is selected

❏ CHANNEL SELECT (Channel selection)
1
❏ TO MATRIX
1
2
3
4
1
SELECT (Channel selection)
2
Except for the fact that your editing applies to a MIX channel, this is the
same as the channel selection for an input channel (➥ p.26.)
2
LIBRARY
Accesses the Output Channel Library. Click this button to open the
OUTPUT CH page of the Library window.
3
PATCH (Output patch)
Selects the output source assigned to the Mix channel (for the selectable
output sources, ➥ p.17.)
3
1
MATRIX send level
This adjusts the send level of the signal sent from the MIX channel to the MATRIX buses.
2
PRE (PRE on/off)
Select either PRE or POST as the position from which the signal is sent from the MIX
channel to the MATRIX bus. PRE EQ or PRE FADER is selected if this is on, or POST
FADER is selected if this is off. The PRE EQ/PRE FADER setting can be made in the Mixer
Setup dialogbox.
Right-click the PRE button to display a context-sensitive menu that will enable you
NOTE
to specify ALL PRE, ALL POST, or other options.
HINT
• If you are using MATRIX buses in stereo,
the knob for the odd-numbered bus will be
PAN or BALANCE.
• The stereo/mono status can be specified in
the Mixer Setup dialogbox.
3
ON (MATRIX send on/off)
This is an on/off switch for the signal sent from the MIX channel to the MATRIX bus.
4
Channel name
This section indicates the MATRIX channel name.
37
Knob of odd-numbered side
CL Editor Owner's Manual