Omron GRT1-PNT - DATASHEET 2 Operation Manual page 106

Service Code
Data
Error Codes
94
For normal completion, the value when the left-most bit of the service code
specified in the command turns ON is stored as shown in the following table.
/i
Function Command service code
Write data 10 Hex
Read data 0E Hex
Reset 05 Hex
Save 16 Hex
When an error response is returned for an explicit message, the value is
always 94 Hex.
Read data is included only when a read command is executed.
The explicit message error codes as listed in the following table.
/i
Response Error name
code
08FF Service not supported
09FF Invalid Attribute value
16FF Object does not exist
15FF Too much data
13FF Not enough data
0CFF Object state conflict
20FF Invalid parameter
0EFF Attribute not settable
10FF Device state conflict
14FF Attribute not supported
19FF Store operation failure
2AFF Group 2 only server
general failure
Response service code
90 Hex
8E Hex
85 Hex
96 Hex
Cause
The Service code is incorrect.
The specified Attribute value is not supported.
The data written was outside valid range.
The specified Instance ID is not supported.
The data is larger than the specified size.
The data is smaller than the specified size.
The specified command cannot be executed
due to an internal error.
The specified operation command data is not
supported.
An Attribute ID supported only for reading has
been executed for a write service code.
The specified command cannot be executed
due to an internal error.
The specified Attribute is not supported.
The data cannot be stored in memory.
The specified command or Attribute is not
supported or the Attribute was not set.