Omron CJ - REFERENCE MANUAL 02-2010 Reference Manual page 329

Table of Contents

XFER(070) copies N words beginning with S

(S to S+(N-1)) to the N words beginning with

D (D to D+(N-1)).

• It is possible for the source words and

destination words to overlap, so XFER(070)

can perform word-shift operations.

• The specified source and destination data

areas can overlap (word shift).

• Be sure that the source words (S to S+N-1) and destination words (D to D+N-1) do not exceed the

end of the data area.

• Some time will be required to complete XFER(070) when a large number of words is being

transferred. Even if an interrupt occurs, execution of this instruction will not be interrupted and

execution of the interrupt task will be started after execution of XFER(070) has been completed. If

power is interrupted during execution of XFER(070), execution may not be completed, i.e., all of the

specified data may not be transferred. One XFER(070) instruction can be replaced with two

XFER(070) instructions to help avoid this problem.

Example Programming

When CIO 0.00 is ON in the following example, the 10 words D100 through D109 are copied to D200

through D209.

CS/CJ/NSJ Series Instructions Reference Manual (W474)

3. Instructions

Chapters

Table of Contents