Monitoring The Audio Signal Via Headphones; Synchronizing Transmitters And Ek 2000 Iem Receivers Via The Infra-Red Interface - Sennheiser SR 2000 IEM - ANNEXE 1 Instruction Manual

To
To

Monitoring the audio signal via headphones

CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
Stereo Transmitter SR 2000 IEM
Synchronizing transmitters and EK 2000 IEM receivers via the
infra-red interface
Synchronization allows you to quickly and easily transfer transmitter and receiver settings
from one device to the other, especially if you want to configure a multi-channel system.
There are two transfer directions:
1.
2. Sync: Transfer from a transmitter to a receiver
Press the jog dial.
The RF signal is deactivated. The transmission icon
the display backlighting changes from orange to red and
alternation with the standard display.
activate the RF signal:
Press the STANDBY
"RF Mute Off?" appears on the display pane.
Press the jog dial.
The RF signal is activated and the transmission icon
backlighting changes from red to orange.
deactivate the RF signal on switch-on:
See "offline operation" on page 13.
Set the headphone volume control
headphones on.
Do not continuously expose yourself to high volumes.
Set the headphone volume control
Connect headphones with a ¼" (6.3 mm) stereo jack plug to the headphone output
Gradually increase the volume and monitor the audio signal with the lowest possible
volume.
Easy Setup Sync: Transfer from the receiver to one or several transmitters
Once you have performed a frequency preset scan with a receiver, you can use the
Setup Sync function to transfer unused frequency presets from the receiver to the
transmitters via the infra-red interface. In order to set up a multi-channel system, you
use the diversity receiver to transfer the first unused channel from the selected
frequency bank to the first transmitter and the next unused channel to the second
transmitter and so on, thus ensuring that all transmitters of a multi-channel system
operate on suitable frequencies.
Once you have selected and set the desired receiver settings on the transmitter (either
manually or using the Easy Setup Sync
receiver. This configures the receiver and establishes a transmission link between
transmitter and receiver.
button.
to the minimum position before putting the
to the minimum position.
function), you transfer these settings to a
Using the transmitter
is not displayed. In addition,
"RF Mute" flashes in
is displayed. The display
Easy
15
.