Using The Transmitter; Switching The Transmitter On/Off - Sennheiser SR 2000 IEM - ANNEXE 1 Instruction Manual

B
100 - 240V
50/60Hz 0.2 A ETHERNET RJ-45

Using the transmitter

To establish a transmission link, proceed as follows:
1. Switch the transmitter on (see next section).
2. Switch the EK 2000 IEM receiver on (see the instruction manual of the receiver).
If you cannot establish a transmission link between the transmitter and the EK 2000 IEM
receiver, read the chapter "Synchronizing the transmitter with the EK 2000 IEM receiver" on
page 30.

Switching the transmitter on/off

To switch the transmitter
0**
To switch the transmitter on and to
To
Pass the mains cable through the cable grip
Connect the mains cable to the mains socket
Plug the mains plug into the wall socket.
The transmission link is established.
It is vital to observe the notes on frequency selection on page 30.
on (online operation):
Briefly press the STANDBY
The transmitter switches on and the standard display appears.
The transmitter transmits an RF signal and the transmission icon
Keep the STANDBY
panel.
Press the jog dial.
The transmission frequency is displayed but the transmitter does not transmit an
RF signal. The transmission icon
backlighting changes from orange to red and
with the standard display.
B.Ch: 5.14 **2000**
552.300
EQ
Standard -18dB
Use this function to prepare a transmitter for use during live operation without
causing interference to existing transmission links.
activate the RF signal:
Press the STANDBY
"RF Mute Off?" appears on the display panel.
.
.
.
button
deactivate the RF signal on switch-on
button pressed until "RF Mute
is not displayed. In addition, the display
MHz
button .
Using the transmitter
is displayed.
(offline operation):
On?" appears on the display
"RF Mute" flashes in alternation
13